About the F0-4AD2DA-2
The Automation Direct Facts Engineering Koyo F0-4AD2DA-2 is a combination analog current module. A combination unit, it features four channel in and two channel out ports. Incoming analog voltage data is converted to digital signals, while outgoing digital signals are converted into analog. The module belongs to a series of devices compatible with DirectLogic 05 and DirectLogic 06 programmable logic controllers. When installed in the PLC, all input/output channels are updated in a single scan of the microprocessor.
User selectable input ranges are a highlighted feature of the module. A jumper switch allows the user to select either 0-5VDC and 0-10VDC input ranges. As the module interacts with a microprocessor, the PLC must have certain software requirements. DL05 controllers need firmware version 3.30 or later and DirectSOFT32 version 3.0c or later. If in a DL06 PLC, install firmware version 1.00 or later and DirectSOFT32 version V4.0, build 16 or later.
Following proper installation and storage parameters is necessary to maintain F0-4AD2DA-2. Installation of the module is simple, with the terminal block able to be removed without interfering with the wiring. Ambient operating temperatures should be monitored, as the acceptable range falls between 0℃ and 60℃, or 32℉ and 140℉. Storage temperatures, on the other hand, can measure as low as -20℃, or -4℉, and as high as 70℃, or 158℉. Automation Direct provided technical support for the F0-4AD2DA-2 module. Be sure to refer to the device’s user manual and datasheet for all safety and technical information.
AX Control is happy to speak with you about all your automation needs. Please contact our office for pricing on part repairs and replacements.
