About the 620L 0180 400 0010 US ENW 0000 000 B0 000 000
The Eurotherm 620L 0180 400 0010 US ENW 0000 000 B0 000 000 enables speed control of induction motors with an encoder. It also provides for a co-processor and ports for a fibre optic communications network.
Starting the Eurotherm 620L 0180 400 0010 US ENW 0000 000 B0 000 000 for the first time can cause a risk to injury to the operator and persons around the device, property damage, damage to other devices, and damage to the components. To reduce the risk you should perform an assessment of the installation and components. Check the main power cables and make sure they carry the correct voltage. Under voltage or over voltage would cause damage or unreliable operation. Confer with an engineer or electrician who is familiar with the installation if you are not sure of the voltage. Also check the voltage of the auxiliary power supply cables.
Observe the label on the motor and make sure the motor armature voltage and current rating is what you expect. You might need to provide this information to an electrician or engineer to make sure it conforms to expectations. The power, control, motor, and earth connections must be checked. Pull on the connections and make sure they are secure and look for exposed wires and frayed wires.
Damage to components and other devices can occur during installation. Check for cracks and broken components. Closely look at the components and check for debris that might have become lodged during installation. This might be metal pieces, small screws or bolts, and bits of wire.
