About the 620L-0007-400-0010-UK-ENW-0000-000-B0-000-000
The Eurotherm 620L-0007-400-0010-UK-ENW-0000-000-B0-000-000 enables speed control of induction motors with an encoder. It also provides for a co-processor and ports for a fibre optic communications network.
Safety is always the primary consideration in the workplace so it is important to follow some basic guidelines when starting the Eurotherm 620L-0007-400-0010-UK-ENW-0000-000-B0-000-000 for the first time. Make sure that other workers are not at risk of injury when the device is started. Make sure they are at a safe distance and are not operating equipment. Try not to inconvenience others at the same time.
With your hand make sure the motor spins freely in both directions. You could easily damage the motor, other components, or cause injury if the motor is jammed. Make sure the startup will not damage other devices nearby.
Remove the fuses from the power supply or switch the circuit breakers on the power supply to cut off all external power. Observe the control terminals and if any of them are not used, check the specifications to see if they should be tied up or down.
The setpoint speed controls are set by parameters in the application program. Make sure they are set to zero speed before you start the device for the first time.
Once complete, you can replace the fuses on the power supply or switch on the circuit breaker to start the motor.
