About the FRN010G11S-2UX
FRN010G11S-2UX is a three phase inversion drive developed for the Fuji Electric Frenic 5000 G11S series. Its use as a general purpose drive allows for users to apply this inverter in a number of factory settings. System integrated dynamic torque vector control uses high speed calculations to determine the motor power needed for a specific load.
Motors on this drive measure at 10 HP. Sourced input ranges to the device can range from 200 V to 230 V with a frequency of 50/60 Hz. The maximum input voltage this drive can sustain rates at 240 VAC. Output voltages produced by the drive resemble the input ranges, with 200 to 230 V accepted with a frequency range of 0.1 to 400 Hz.
Remote operation of FRN010G11S-2UX is possible if the keypad found on the front of the drive is removed. This keypad includes a four digit LED screen as well as an LCD monitor. The device features six programmed languages, allowing for a variety of workplaces. Applications of this drive are nearly limitless, with it capable of working with crushers, presses, and knitting machines.
Provided storage and installation parameters should be followed to prevent any damages to the device. When operating, ambient temperatures should range no lower than 14℉ (-10℃) and no higher than 122℉ (50℃). Refer to the series manual and datasheet for a complete guide to installing FRN010G11S-2UX. Technical support was originally provided by Fuji.
Our friendly and knowledgeable staff at AX Control is happy to assist with all of your automation needs. Please contact our office by phone or email to receive current prices on all available parts and repairs.
