About the 193X267BAG01
The GE Standard Regulator Card 193X267BAG01 is typically used in a one quadrant or four quadrant driver of a 3-phase, full wave, SCR drive system. The 193X267BAG01 features reference, feedback, regulating, current limit, static relay, and diagnostic functions.
The 193X267BAG01 performs logic controlled by the conventional relays. Apply system reference, apply auxiliary preset reference, remove linear time preconditioning, remove regulator unity gain, remove feedback inhibit, and remove driver reconditioning is the logic performed by the relays.
The printed circuit board is a delicate component and can be damaged if not handled appropriately. Rough treatment can cause the components to bend, break off, or be damaged. Static electricity can build up in the board or on your body so standard guidelines must be followed.
The board is delivered by the carrier in a shipping box. Inspect the box and look for signs of damage such as dents in the cardboard, rips, and signs of water damage. Open the box and view the model number on the outer edge of the board and make sure it matches the model number printed on the label on the outside of the box. Also make sure the model is the board you ordered as a replacement for your drive.
Best practice is to store the box in safe place where others cannot easily access it. Other individuals that are not familiar with the best practices might accidently damage it or cause static to build up in it. When it is time to install it, wear a wrist strap.
