About the 193X823ACG01
The 193X823ACG01 is a Regulator Card created by General Electric for their SCR Drive, the Speed Variator Drive, or other compatible drive systems.
Unlike most printed circuit boards in the 193x series, the 193X823ACG01 is built without a front panel attached. The board has four small factory drilled holes that are offset from each corner. The board number is etched into one corner.
The 193X823ACG01 is built with seventeen bias jumpers. These are marked in two ways. First, all of these components are numbered “63.” Second, each component carries a separate number or number/letter designator. The three bias jumpers on the top edge of the board are 3M, 3G, and 3H. The four jumpers in the center of the board are 3J, 3L, 3K and 6. The ten jumpers lined up on the bottom edge of the board are 13,10, 5, 3, 1, 12, 4A, 4, 7, and 9.
The 193X823ACG01 is built with five transistors. The board has seven polyester vinyl capacitors, including two that have been mounted vertically. The board has six other capacitors of varying materials. This includes two large Sprague capacitors marked 100 µf 25DC 30D. This board uses both metal film and carbon composite resistors. Diodes tend to be ceramic. The 193X823ACG01 has four additional components. These large round silver components are marked 104X139D0010.
All static-sensitive boards are carefully wrapped in anti-static material before they are packed for shipment from the AX Control warehouse. If you have questions about your shipping options, please consult with your representative as you place your order.
