531X122PCNAHG1

About the 531X122PCNAHG1

The GE Power Connection Board 531X122PCNAHG1 is a renewal part for multiple original equipment power connection boards. Sometimes it becomes necessary to remove, replace, or relocate components on the 531X122PCNAHG1 board from one version of the board to the next version. If you find that a jumper or connector or other components are missing on the replacement board, refer to the information that comes with the board for instructions. The board is tested thoroughly before release and all discrepancies are evaluated and the workarounds are go through a careful analysis.

Only two jumpers on the 531X122PCNAHG1 board are used for configuration purposes but to use the board, the jumpers must be set. The jumpers configure the board to output the voltage range required for your drive. Find your drive model in the 531X122PCNAHG1 board manual and it lists the jumper settings for the drive. Each jumper has 7 pins and when you insert the jumpers over the right pins, it defines the voltages for your drive.

The procedure for changing the jumper positions is straightforward but requires you to follow some guidelines. When the board is delivered to you it is packaged in a protective bag that prevents the buildup of static. Keep the board in the bag and it is best to leave it in the box until you install it. Pull the board out and place the bag on a clean surface like a workbench or desk. Use your hands or pliers to remove the jumpers from the factory settings. Carefully insert the jumpers in the pins for your drive.