531X133PRUAMG1

About the 531X133PRUAMG1

The 531X133PRUAMG1 is a PCB board component made by GE.  This PCB is designed for use within several general purpose drive systems from GE.  Please refer to your particular system’s user guide or manual to ascertain compatibility.

The 531X133PRUAMG1 functions as a Process Interface Board.  Interface components typically are used to amplify, isolate, filter, and convert their input signals into output signals that are suitable for their connected control systems.  The PRUAM board is only one version of several available within this series.

The 531X133PRUAMG1 is a square board with a single factory-made drill hole placed in each corner.  The board carries the round GE logo, the board number, and codes like 92/38, 009/01, 002/01, 006/01, and F31X133PRUALG1.  Codes may be located on the front or rear surfaces of the PCB.

The 531X133PRUAMG1 has components that allow connection such as a three-position terminal strip.  This is marked TACH + on one side and TACH - on the other. The board has two vertical pin cable connectors and a single 16-pin (vertical) header connector.  

The 531X133PRUAMG1 is populated by potentiometers (7,) resistor network arrays(5,) resistors (over 100,) diodes, and capacitors.  Capacitors vary in the material used, but include aluminum electrolytic, polyester vinyl and capacitors made from ceramic material.    The board has 15 jumper switches and several TP test points. It has a single switch component (marked “Tach Range,”) with seven individual toggles located on the switch.   If more information about the board or its components is needed, this may be found through GE publications like user guides and manuals.