About the 531X170TBSAFG1
The 531X170TBSAFG1 is a board component manufactured by General Electric. This board was not created for use for any specific system; rather, it is a general purpose board designed for use in various drives from General Electric. Please refer to your drive’s manual or user guide to check for compatibility.
The 531X170TBSAFG1 functions as a TB Option Terminal Board. The board is long and narrow, measuring 11 inches by 2.75 inches. It is factory drilled at each corner to allow for mounting. The board has additional mounting holes drilled along edges and within the body of the board to allow for further stabilization.
The primary components on the 531X170TBSAFG1 are two terminal strips. One of these strips runs the length of the board. The other runs a third of the way down the centerline of the board. The first strip has 54 screw connections. Each is numbered and labeled on the surface of the board. The second terminal strip has 21 screw connections, of which the first eighteen are numbered and labeled on the board surface.
Other components located on the 531X170TBSAFG1 include two cable connectors. Both of these connectors are vertical connectors. One is male and one female. The board also has three header connectors, including a 24-pin connector, a 9-pin connector, and a 16-pin connector. It has a single inductor, a single relay, one polyester vinyl capacitor, one jumper switch, one rectifier diode, and one stab-on connector. There is also one metal film resistor located on the bottom surface of the board. In the top right corner, the board is populated by two switch components. Each switch has four toggles that can be independently manipulated.
The 531X170TBSAFG1 is marked with codes like 002/0, FR00/0, 003/0, and VA-5. It is marked with the board number and the code F31X170TBSADG1. If more information is needed, please refer to GE user guides or manuals.
