DS200AAHA1 | GE Turbine Control | Mark V |
DS200AAHA1 | GE Turbine Control | Mark V |
DS200AAHA1 | GE Turbine Control | Mark V |
❮
❯
AVAILABILITY:
IN STOCK
SHIPS TODAY
Alphanumeric Catalog Number | IS200EDCFG1B |
Fiber Optic Cable Type | Plastic Optical Fiber (POF) and Hard Clad Silica (HCS) |
Field V Input Indicators | 9; R26, R27, R77, R73, R74, R76, R72, R80, and R79 |
LED Light Indicators | 1, Power Supply Indicator |
Manufacturer | GE, General Electric Company |
Power Potential Transformer Scale | 140-1300 V |
Exciter DC Feedback Board IS200EDCFG1B is part of the Excitation Controller series produced by General Electric Company USA. This model is connected to a DC shunt which provides the output feedback. The IS200EDCFG1B board is part of the high voltage interface system. This model is also part of the I/O terminal boards, and this board mainly controls the DC outputs and feedback, as well as current voltages.
The field voltage feedback circuit of the EDCF model provides a total of seven settings on the selector, these settings scale down the bridge voltage, but this all depends on the application that the bridge is set to. The fiber-optic cables that are connected to the IS200EDCFG1B model provide an isolated voltage between the EISB board and the EDCF board, along with high noise immunity.
The field current feedback from your IS200EDCFG1B model is measured across the DC shunt that is located at the SCR bridge. When the field current is running as it should it will generate a low-level signal, that has a maximum value of 500 MV, which will be the input to a different amplifier.
The best manual to use when using the IS200EDCFG1B model is the GEH-6632 EX2100 Excitation Control User’s Guide, information regarding the EDCF model can be found on pages fifty and sixty-four.
The IS200EDCFG1B board has a P1 connector. What are the pin descriptions for this connector?
There are ten jumpers on the IS200EDCFG1B board. What are the descriptions of the JP3 and JP7 jumpers?
If three redundant EDCF boards gave been installed can the exciter continue running if one board has failed?
The IS200EDCFG1B board has an E1 connector what is the description for this connector?
This specific model has a total of nine field voltage input indicators, these indicators will be difficult to replace. Our team of specialists will do everything possible in order to replace or repair these indicators or other faulty mechanisms for you and your business. - AX Control Technical Team
Type | Lead Time | Price | Action |
---|---|---|---|
Repair Service | 1-2 weeks | $1265 |
Our highly skilled technicians can repair your IS200EDCFG1B. All of our repairs come with a 3 Year AX Control Warranty. Please contact us for additional information about our repair process. To receive the repair pricing and lead time listed above please process your repair order via our website. The following repair options may be available upon request:
All PLCs, HMIs, and Turbine Control Boards: | 3 Years |
All AC/DC and Servo Drives: | 2 Years |
All Motors: | 1 Year |
AX Control Inc. sells new surplus and reconditioned products. This website is not sanctioned or approved by any manufacturer or tradename listed.
AX Control Inc. is not an authorized distributor or representative for the listed manufacturers. Designated trademarks, brand names and brands appearing
herein are the property of their respective owners.
Copyright 2025 - AX Control Inc. - All Rights Reserved