About the IC3603A177AB2
The IC3603A177AB2 is a twenty-eight (28) VDC relay module. A relay is an electrical device, typically incorporating an electromagnet, that is activated by a current or signal in one circuit to open or close another circuit. Relays are used where it is necessary to control a circuit by a separate low power signal, or where several circuits must be controlled by one signal. The IC3603A177AB2 has twelve flat head screw ports. The IC3603A177AB2 screws are labeled one through twelve. Between each screw is a small white divider. In each of the corners is a square hole. Between one and two is a circle, between three and four, five and six, seven and eight, are two T’s with the tail facing each number with a line through the T’s. Between nine and ten, and eleven and twelve are two T’s with the tail facing each number. The part number (IC3603A177AB2) is printed on the face of the relay along with General Electric’s company emblem. This faceplate is held onto the device with two screws. The IC3603A177AB2 is a large white rectangular block. On the bottom of the IC3603A177AB2 are two thin metal edges that have two pre-drilled holes in each. These are used to secure the IC3603A177AB2 in place.
If you’d like more information about the IC3603A177AB2 or any other products, please call the trusted staff at AX Control.
**General Electric has provided the initial technical support. The staff at AX Control recommends referring to the original manufacturer's manual for safety procedures and instruction on how to install the part.
