DS3800DCCB1C1C

About the DS3800DCCB1C1C

The GE Multi Cony Coordinator Auxiliary Board DS3800DCCB1C1C features 6 resistor capacitors with identifiers. The IDs are CEMF, IOC, VMTR, IMTR, VFBH, and IFBK. The GE Multi Cony Coordinator Auxiliary Board DS3800DCCB1C1C is also populated with 1 20-pin ribbon cable that serves as the main signal connection to other components in the drive.

The GE Multi Cony Coordinator Auxiliary Board DS3800DCCB1C1C will provide reliable service when properly installed in the drive. However, the need might arise for you to replace the board. To do that requires some consideration and planning before you start. To prevent electric shock and burn, you must remove all power from the drive as the first step.

The drive will have multiple sources of power and all of them can cause a safety concern if not removed from the drive. If you are not familiar with the power supplies connected to the drive, confer with an engineer or installer who is familiar with the installation of the drive. Rectifiers are used to deliver DC power to the drive and they can be disabled by a switch or by removing the fuses from it. If the drive has an AC power source, the current can be removed by moving a switch or a disabling a circuit breaker.

It is important that you use a tester device after you have removed current from the drive to verify that all power is absent from the drive. Without touching any components, use insulated probes and a reliable tester to check for power.