DS3800DGRA1C1B

About the DS3800DGRA1C1B

The GE Regulator Turbine Control Board DS3800DGRA1C1B is designed for secure and easy installation in the drive. The board features one hole in each corner for installation using screws. The GE Regulator Turbine Control Board DS3800DGRA1C1B is populated with 1 trimmer resistor and multiple potentiometers with dial settings. The board is also populated with multiple wire terminals and multiple jumpers.

The wire terminals on the GE Regulator Turbine Control Board DS3800DGRA1C1B are assigned IDs. Some of the IDs are prefixed with C and other are prefixed with R. The prefix is followed by a numeric value. For example, C5, C29, and R74 are some of the IDs. The IDs are referenced in the printed installation guide. The guide describes the function of the wire terminals and how installing wires between the terminals changes the board processing. To use a wire terminal, have on hand a wire with bare ends that is appropriate for use as a jumper wire. Use a screwdriver to loosen the terminal screws of the terminals you want to connect. Wrap the bare wire end around the terminals and tighten the screws. Use wires that are the appropriate length and not longer than necessary.

It is best practice to record the wire terminals you have connected. Keep the written records with the other important information about the board. This includes the shipping labels that contains the model and serial numbers, and any written information included in the shipping box. This includes the installation guide, instructions about contacting customer support, and warranty information.