DS3800HCIC1E1E

About the DS3800HCIC1E1E

The GE Mark IV Board DS3800HCIC1E1E is designed for quick installation in the drive. The board features a modular connector on 1 end and retention levers on the other end. The GE Mark IV Board DS3800HCIC1E1E also is populated with 1 40-pin connector located between the retention levers and 1 34-pin connector on the surface of the board. The board is populated with 1 amber indicator LED and standoffs. The board is also populated with 1 socket for an electrically erasable programmable read-only memory (EEPROM) module and 7 jumpers.

When you receive the replacement GE Mark IV Board DS3800HCIC1E1E there are several tasks to complete before it can be installed. When the original GE Mark IV Board DS3800HCIC1E1E is in stalled in the drive, the jumpers are set to configure the board to use the settings best suited for the drive. The installer confers with the engineers and operators to determine the best configuration settings. When you replace the board, you must make sure the jumpers on the new board match the settings on the defective board. Best practice is for the installer to document the jumper settings used on the original board and keep them with the other important information about the board. The other information about the board is the warranty instructions, customer support information, and any troubleshooting instructions.

Locate the jumper settings and move the jumpers on the new board to match them. When the board is shipped from the factory, the jumpers are set to the default settings. These are the most common settings but they can be changed to accommodate the needs of the drive.