DS3800HDDD1D1E

About the DS3800HDDD1D1E

The DS3800HDDD1D1E is a printed circuit board designed to be used as a diagnostic display. The DS3800HDDD1D1E is manufactured by GE and is a part of the Speedtronic Mark IV series.

The DS3800HDDD1D1E is made up of two distinct parts: the operator panel and the printed circuit board. These are connected by four screws. The panel has been designed to sit above the PCB with enough of a gap to allow the user to access components located on the edge of the card. These include two multi-pin connectors (one on either side of the board, and two thumb-wheeled meters.

The DS3800HDDD1D1E has ten LED displays. This includes six LED strips (three red and three amber) and four individual LEDs (three amber and one red.) The individual displays are on the left side of the PCB above a switch (marked reset,) and are marked Drive ok/Datalink active/Ready to run/Fault.

The middle LEDs are red. These are subdivided, labeled, numbered and listed as motor faults, converter faults, and alarms.

The right side LED strips are amber. These are subdivided, labeled, numbered and listed as drive status, reference selection, and status.

The DS3800HDDD1D1E has been designed with multiple resistors and integrated circuits. It has two capacitors of differing values. The lower edge of the DS3800HDDD1D1E is marked with letters A through J for alignment purposes. The DS3800HDDD1D1E has been factory drilled at all four corners.

Installation guidelines for the DS3800HDDD1D1E can be found in manuals or data sheets published by GE for this product. Technical support was provided for the DS3800HDDD1D1E by GE.