DS3800HITA

About the DS3800HITA

The DS3800HITA is a printed circuit board manufactured by GE as part of the Mark IV/Speedtronic series. The DS3800HITA has been designed as an Input/Output (I/O) control board.

The specifications of the DS3800HITA are as follows:

• factory drilled on all four corners of the card.

• labeled at the top edge of the card A through J, with marks between each letter for alignment.

• The left edge of the board is taken up by one AMP connector, marked 218A4553-1 AMP 533002-1 8442.

• top right edge of the board has nine LEDs. Eight are red, labeled 0-7, and one is amber, labeled IMOK.

• bottom right edge of the board consists of fifteen test points. These are labeled 1-7, OX, VA, VB, VC, OUT0, OUT1, OUT2, DCOM.

• seven jumpers located on the board. Jumpers 1-5 are in a line and have the option of A or B. Jumper 6 is located in the upper right of the board near the LEDs and has the option of SHORT or LONG. Jumper 7 is located near the top left of the board and has the option of ON or OFF.

• has 4 resistor networks located on the board

The board is designed with multiple small capacitors located on the board, as well as ceramic covered, metal film resistors of differing values. It has multiple integrated circuits including Eproms and DIP components.

Technical support for the DS3800HITA was originally provided by GE. Please reference their manuals and datasheet publications for information on proper installation guidelines.