DS3800HPLA1B1C

About the DS3800HPLA1B1C

The GE Panel Interface Board DS3800HPLA1B1C is designed for quick installation in the drive. The board features 1 hole in each corner. The board can be secured with screws. The board is populated with 1 40-pin connector embedded on the board.The GE Panel Interface Board DS3800HPLA1B1C daughter card also is populated with 3 red indicator LEDs. The board is also populated with 2 sockets for electrically erasable programmable read-only memory (EEPROM) modules, 7 jumpers, and 2 trimmer resistors.

The GE Panel Interface Board DS3800HPLA1B1C daughter card is an integral component of the board. It provides basic functionality used by the board. It is connected to the board through a ribbon cable that attaches to the board through a plastic connector. The daughter card is populated with jumpers, wire terminals, red indicator LEDs, and 1 potentiometer with a dial-type adjustment. To use the potentiometer, attach the probes on a testing device to the proper circuits on the board. Turn the dial until the proper reading is indicated on the testing device. Refrain from moving the dial after the proper reading is indicated.

The GE Panel Interface Board DS3800HPLA1B1C is populated with 2 EEPROM  sockets. 1 or 2 modules can be added to the sockets. The modules store the code that instructs the processing activity on the board. The code can be erased and new code installed on the modules. This might be helpful if new code is available that resolves some issues you have encountered on the board.