DS3800HPLA1E1C

About the DS3800HPLA1E1C

The GE Panel Interface Board DS3800HPLA1E1C is designed for quick installation in the drive. The board features 1 hole in each corner. The board can be secured with screws. The board is populated with 1 40-pin connector embedded on the board. The GE Panel Interface Board DS3800HPLA1E1C daughter card also is populated with 3 red indicator LEDs. The board is also populated with 2 sockets for electrically erasable programmable read-only memory (EEPROM) modules, 7 jumpers, and 2 trimmer resistors.

The GE Panel Interface Board DS3800HPLA1E1C daughter card is populated with wire terminals that enable a technician to install wires, capacitors, resistors, or other components between the wire terminals. They provide a quick method of modifying a circuit. If you add a capacitor to the daughter card, consider the following information if you handle the daughter card. The capacitor is designed to store high-voltage electrical energy. When the servicer removes all power from the drive, the capacitors might still contain high-voltage electricity that can injure a technician or others who come in contact with it.

To prevent a serious electric shock, wait 30 seconds before you touch or handle the daughter card. This gives time for the high-voltage electricity to dissipate which removes the danger. Place the daughter card on a static safe surface when you handle it. This can be a specially designed static free mat or a flattened static protective bag. Wear a wrist strap that is connected properly to your person and a grounded surface.