DS3800HSAA1K1C

About the DS3800HSAA1K1C

The GE Dom Plus Servo Amp Board DS3800HSAA1K1C features a modular connector on 1 end and retention levers on the other end. The board is populated with a heat sink. The analog/digital converter is a component embedded on the board. The GE Dom Plus Servo Amp Board DS3800HSAA1K1C is also populated with 1 34-pin connector and 1 socket for electrically erasable programmable read-only memory (EEPROM) modules. The board is also populated with 3 trimmer resistors.

The GE Dom Plus Servo Amp Board DS3800HSAA1K1C is populated with 1 relay switch. The relay switch receives control signals to open or close a circuit. This circuit controls a device in the drive. The board also is populated with multiple jumpers. The jumpers all are 3-pin jumpers. 2 of the pins are always covered by the jumper. The jumper cause the 2 covered pins to create a circuit that defines the configuration setting. The jumper can cover either pins 1 and 2 or pins 2 and 3. The jumpers have IDs that begin with J. The J is a prefix which is followed by a number. For example, J1, J2, and J5 are some jumper IDs.

The modular connector is located opposite of the retention levers. When the GE Dom Plus Servo Amp Board DS3800HSAA1K1C is installed in the board rack the modular connector connects to another modular connector in the drive. They enable current to pass to the board. The modular connectors also carry control signals. The retention levers hold the modular connectors together so the connection between them is secure.