DS3800HSCG1E1E

About the DS3800HSCG1E1E

The GE High Level Isolator Board DS3800HSCG1E1E is designed for quick installation in the drive. The board features a modular connector on 1 end and retention levers on the other end. The GE High Level Isolator Board DS3800HSCG1E1E also is populated with 8 jumpers and 1 trimmer resistor. The board also is populated with 1 34-pin connector with retention levers and 1 programmable interrupt controller.

The GE High Level Isolator Board DS3800HSCG1E1E is part of a high-voltage drive that requires careful planning before the drive can be installed. Excessive heat is a problem because the drive is often installed with other drives and high-voltage equipment. The drives and equipment generate heat that can not be allowed to build up in the room with the drive. Fans mounted on the walls can be an effective solution. They keep the heat from building up and move the hot air from the room. Exhaust  hoods can also be useful. They are mounted over the equipment and remove hot air and dust from the room.

If the room gets too hot, the drive will automatically shutdown. This causes a trip condition. The drive identifies several trip conditions to keep the drive from damage.

Besides excessive heat, another trip condition is over current. This is when the power sources expose the drive to too much power. This can damage components and cause a fire or injury. Another trip condition is overload. This is when the drive draws too much current to perform a task. It is similar to the over current condition.