DS3800HSCG1E1F

About the DS3800HSCG1E1F

The GE High Level Isolator Board DS3800HSCG1E1F is designed for quick installation in the drive. The board features a modular connector on 1 end and retention levers on the other end. The GE High Level Isolator Board DS3800HSCG1E1F also is populated with 8 jumpers and 1 trimmer resistor. The board also is populated with 1 34-pin connector with retention levers and 1 programmable interrupt controller.

If the GE High Level Isolator Board DS3800HSCG1E1F is replaced, only a qualified servicer or installer can perform the task. This is because of the high-voltage electricity that enters the drive during normal processing and the knowledge it takes to work safely on the drive. Another concern is the motor and the other moving parts that can injure individuals in the surrounding area.

Before the servicers starts any procedure, the first step is to inspect the area around the drive. The floor must be free of dirt, dust, oil, grease and clutter. If the floor is moist or has puddles of standing water, it must be cleaned because the water is a conductive material and can cause a shock. Use towels to dry any water on the floor. If the moisture is caused by condensation and it is a common occurrence, you might consider installing dehumidifiers to dry the air. This would help eliminate the wet floors. Oil and grease must also be removed by using degreasing agents or a detergent. Once the oil and grease are removed, allow the floor to dry. Extension cords without a ground wire are also a hazard. Remove them from the area or replace them with 3-wire extension cords.