DS3800NAIA1E1F

About the DS3800NAIA1E1F

General Electric developed the DS3800NAIA1E1F to fit into their Mark IV/Speedtronic line. The Mark IV, which was designed for steam and gas turbine management, can keep the turbine system operating within safe parameters. It can also automate start-up and shutdown procedures.

The DS3800NAIA1E1F is designed with two extractor clips attached to its right edge. These nylon inserter/extractor clips allow for faster and easier extraction of the board and eliminate the need for special tools, especially during extraction from tight locations. They also protect the board, as they act as a handle for the technician, who no longer needs to grasp delicate circuitry or components.

The DS3800NAIA1E1F is factory-drilled. It is marked for alignment along its top edge and marked "6BA07" on its bottom edge. All components on the board are individually marked.

The DS3800NAIA1E1F is built with three rotary potentiometers and three trim potentiometers. It has one resistor network. It is built with metal film resistors. It has 200V yellow film capacitors (thirty-two, placed in nine horizontal lines,) and various smaller capacitors. The DS3800NAIA1E1F has five integrated circuits. It communicates with other PCBs by way of two connectors (one male and one female) positioned along each of its short edges.

Technical support for the DS3800NAIA1E1F including installation guidelines may be accessed through publications like datasheets and manuals originally distributed by GE.

AX Control offers a variety of services, including repair service, comprehensive warranties, exchange programs, and same day shipping. Call and speak to one of our team for more information, or send us an email!