DS3800NAIB1D1E

About the DS3800NAIB1D1E

The Multi-volt buffer board DS3800NAIB1D1E has been created by GE as part of their Speedtronic Mark IV system. The Mark IV was designed for gas and steam turbine control and was built with integrated chipsets that work with each other to minimize downtime. The Mark IV can be used to monitor the turbines and their auxiliaries, to sequence them for startup and shutdown, and to keep the system operating within safe parameters. It can also be utilized for water, air and fuel emissions control.

The DS3800NAIB1D1E reduces power consumption by using frequency and dynamic voltage scaling. It has the following specifications:

• It has been factory-drilled.

• It has multiple integrated circuits.

• It has been alignment marked.

• It can communicate with other PCBs via male and female connectors located on its short edges.

• It has six potentiometers (three trim and three rotary.)

• It has 32 200V capacitors. These are placed in parallel lines across the long dimension of the board.

• It has 31 smaller capacitors. These sit parallel to the larger capacitors.

• It is built with one resistor network array.

• It has two extractor clips on its right corners. These aid in the removal of the board from a restricted space, and allow the technician to pull the board without touching any of the circuitry.

Technical support publications for the DS3800NAIB1D1E were made available by GE. This includes data sheets and manuals. Installation guidelines may be found within these publications.

AxControl can help with all your automation needs. Call or email our team today.