DS3800NASB1B1C

About the DS3800NASB1B1C

General Electric created the DS3800NASB1B1C PCB as a part of their Speedtronic Mark IV system. The Mark IV, which was designed for steam and gas turbine control, was designed with two-out-of-three voting redundancies on all critical controls and protection parameters in the system. In this way, the Mark IV maximizes efficiency and minimizes downtime.

The DS3800NASB1B1C has been built:

• -with factory drilled holes for mounting options. These include two holes per corner, another drill hole set slightly off from each corner, and a final hole placed dead-center of the PCB.

• -with alignment markings along two edges. This includes letters (A-J) and numbers (10-80.) It is marked 6BA03.

• -with a 12-prong male connector along its right edge.

• -with 2-prong male connectors placed on three edges. These are 90 degree connectors.

• -with 5-prong male connectors lined up together along its top edge. There are four connectors.

• -with three transistors.

• -with 14 test points. While TP1 through TP10 sit parallel to the bottom edge of the board, they are not sequential.

• -with seven ceramic Ceramite disc capacitors

• -with one capacitor (yellow) 708D1 600VDC

• -with two trimmer potentiometers.

• -with two HiPot transformers. Max operating temperature is 155 degrees Celsius.

• -with seven integrated circuits.

Installation and repair guidelines, as well as maintenance schedules for the DS3800NASB1B1C, may be found in manuals, data sheets, or other technical support publications from the original manufacturer.

AXControl can help you with all your automation needs. Our sales team is happy to answer questions by phone or by email about any product or service.