DS3800NFCF1F1D

About the DS3800NFCF1F1D

Greater Product Series Information

The DS3800NFCF1F1D is a PCB from GE for the Mark IV/Speedtronic series. The Mark IV, which was created for gas/steam turbine management, helps maintain turbine systems within safe operating parameters. It can also automate certain procedures, including shutdown and startup. This DS3800NFCF1F1D Firing Circuit Board device, alongside its greater general Mark IV Series, is really not approved for very many hazardous locations as it is not a HazLoc PCB.

Hardware Tips and Specifications

The DS3800NFCF1F1D is built with:

• 42 circuits.
• crystal oscillators set at 11.000 MHz and an 8-bit static MOS RAM chip with 2K bit static cells organized as 256 x 8.
• a minimum access time of 400ns to permit use with no wait states in 8085AH CPU.
• synchronous 4-bit up/down counters which have cascading circuitry provided internally and an individual preset to each flip-flop.
• fifteen LEDs
• twenty-one transistors
• twenty-nine test points
• two jumpers
• three connectors for communicating with other boards, including a 10-pin vertical connector and two 218A4637-P4 connectors.
• The board is built with multiple capacitors, diodes, and resistors.

Interfacing Tips and Specifications

The DS3800NFCF1F1D can act as a motherboard for the smaller DS3800DFCF. When the DS3800DFCF is present, the larger board has access to more components, including ammeters and jumper switches. Four nylon pins on the left side of DS3800NFCF1F1D are meant to support the corners of the auxiliary. The board is held in place by seventeen board-to-board pins. Installation and maintenance guidelines may be found in datasheets and manuals for the DS3800NFCF1F1D. Technical support publications were distributed by GE. Our team at AX Control is ready to help with all your automation needs. Please contact us if you have a question!