DS3800NMEC1G1H

About the DS3800NMEC1G1H

The DS3800NMEC1G1H is considered a motor exciter control board for the Speedtronic (Mark IV) line from General Electric. The DS3800NMEC1G1H and other circuit boards in the Speedtronic Mark IV line are used to control and run gas and steam turbines. I turbine uses an internal combustion engine to mix fuel and air to cause a contained explosion. This explosion creates a series of gases that are under pressure and force there way out causing the turbine to move. The energy created by the moving turbine is then harnessed and used for a multitude of other purposes. The DS3800NMEC1G1H has nearly one-hundred resistors (restrict the amount of energy that flows through them). The DS3800NMEC1G1H has diodes (allow energy to follow in only one direction)and capacitors (hold energy in an electric field). The DS3800NMEC1G1H has six masculine connection points to connect with the circuit boards surrounding it. The DS3800NMEC1G1H has ten half circle black transistors. The DS3800NMEC1G1H has thirty-five integrated circuits which hold all the programming information for the DS3800NMEC1G1H. The integrated circuits are split into EEPROM and EPROMs. The only difference between these two is EPROM can be altered while EEPROMs cannot. The DS3800NMEC1G1H has a variable resistor or Potentiometer. The variable resistor can be identified by the black knob with a white arrow in the center. This knob allows the worker to adjust the variable resistor from zero to one-hundred, with ten-degree increments. The DS3800NMEC1G1H also has a silver square called a crystal oscillator which uses a crystal to create a high and precise frequency.

Call AX Control for more information.