DS3800NRMA1C1C

About the DS3800NRMA1C1C

Manufactured by GE, the DS3800NRMA1C1C is a PCB component for the Mark IV series.  This series was created by GE to manage gas or steam turbines and has several interconnected microprocessor-run platforms.  While monitoring the turbine system for issues like high pressure, fire, vibration, and loss of flame, these platforms make adjustments to keep the turbine system running and to protect it from any issues.  The MKIV can also automate some procedures, such as start-up, shutdown, and control sequencing.

The DS3800NRMA1C1C is built with the following specs and components:

• It has twenty-one circuits.

• It has two mating connectors.  This includes one right-angled female mating connector and one right-angled 17-pin male connector.

• The code 6BA04 is placed on the bottom edge.

• Each corner is factory-drilled.

• It has twelve test points.

• Two circuit board stiffeners are installed.  These are placed on the long dimensions of the board, on the top and bottom edges.

• It has eight LEDs.  There are three red and five amber LEDs.

• It has one Augat plug.  The Augat plug is a four by six connector.

• Ten board-to-board pins are attached to the surface.

• It has four nylon spacers attached to its surface.

• It has eighteen transistors.

• The board is built with extractor clips.

• The board primarily uses ceramic covered metal film resistors.

• Most capacitors are made of polyester vinyl.  

Our team at AX Control will ship this component to you protected by a static-reducing sleeve or covering. We suggest technicians review OEM publications like manuals or datasheets in your company’s possession before beginning installation.  Technical support for the DS3800NRMA1C1C was provided by GE.