DS200CVMAG3AEB

Product Description

The GE Generator Control Turbine Board DS200CVMAG3AEB contains two 16-pin connectors and one 2-pin connector. The board also is populated with 6 test points. The test points that populate the GE Generator Control Turbine Board DS200CVMAG3AEB are useful for testing the activity of  six specific circuits on the board.  Only a qualified servicer can test the board and only the approved testing equipment should be used. The equipment must be calibrated for the purpose and all controls must be set correctly as required for the circuit being tested. The probes attached to the tester must be compatible with the tester and also must be in good condition with the insulation intact, if insulation is present.

You can test the board only when power is removed from the board.

Another method of diagnosing conditions in the board is to use the diagnostic tools that are available from the drive. When you run the diagnostics, it provides a complete accounting of the condition of all components of the drive. You can run the tool from the drive and download the results to a laptop or other device. If you replace a component, run the diagnostic tool again and compare the results to see if the condition is resolved.

If you suspect the DS200CVMAG3AEB is the source of the problem, you can replace the board in the drive and run the diagnostic program again. If the tool indicates the problem still exists, inspect the diagnostic results and determine the source of the problem.