About the DS200FCSAG1
The DS200FCSAG1 is a GE Motors & Industrial Systems board component fabricated for use within the company’s Speedtronic systems. This DS200FCSAG1 board is primarily used in the Mark V series of turbine control systems, which was one of the first of the Speedtronic steam and gas control systems to be designed with TMR (triple modular redundant) controls. As defined in original General Electric instructional manual materials, this DS200FCSAG1 PCB is more specifically definable as a Current Sensor Interface Board. No longer manufactured by GE, the DS200FCSAG1 is available from AX Control as a refurbished unit within a Mark V legacy series. We also sell the DS200FCSAG1 as unused liquidated surplus when available.
Hardware Tips and Specifications
The DS200FCSAG1 is a smaller rectangular board with only a few components. It is factory drilled in each corner for convenient and safe installation and has smaller notches located along two edges. Two of these drill-holes are ringed in conductive material. These same edges are marked for alignment purposes. The board is marked with the GE logo, with the DS200FCSAG1 board ID, and with codes like 6BA02.
Components on the surface of the DS200FCSAG1 include multiple connectors including two vertical pin header connectors marked LEM1 and LEM2, five terminal strips, and two Mate-N-Lok connectors. The Mate-N-Lok connectors made available to the assembly of this DS200FCSAG1 printed circuit board are labeled CSPL and LEMPS. The first CSPL connector has twelve positions and the other LEMPS connector has three positions. The terminal strips in the assembly of this DS200FCSAG1 Current Sensor Interface Board each consist of a single screw connection, and are labeled Gnd, CT1P, CT2P, CT1N, and CT2N respectively. Other DS200FCSAG1 board components include two polyester vinyl capacitors, two electrolytic capacitors, four resistors, and sixteen diodes that are placed on the board in eight pairs; most of these listed hardware components have been included with basic voltage protections in mind. All of the hardware components in the assembly of this DS200FCSAG1 Current Sensor Interface Board should receive at least some basis of daily wear and tear protection from the basic thick layer of normal-style PCB coating that has been applied to the normal Mark V Series assembly of this product. More information about the DS200FCSAG1 can be found through GE technical support products like data sheets, user guides, and product manuals. All original technical support for the DS200FCSAG1 and other MKIV components was provided by General Electric.
