About the DS200PLIBG2A
This unit is designated under the ID of DS200PLIBG2A and is a part of the DS200 component category from the Speedtronic Mark V series of control drives. These turbine control system drives and drive component circuit boards are manufactured to manage, monitor, and control industrial turbines (both gas-powered and steam-powered).The Speedtronic Mark V control system drives are available from AX Control Inc. as well, and are designed to meet the needs of complex, dynamic behavior turbines, and delivers flexible monitoring and protection. This series was produced by General Electric, whose other industrial automation products we have in stock. The Mark V models are outfitted with a software configurable fault tolerance, as well as online maintenance applications, direct sensor interface, and built-in diagnostic capabilities. The Mark V Seris must be considered obsolete as a whole, given the truth that its manufacture was discontinued due to a retailer-identified whole-series functional obsolescence. While this may be the case, it is still very much desired on the greater promotional marketplace given its status as one of the final-developed GE Mark product series utilizing the Speedtronic control system technology first seen in the initial Mark I Series.
Hardware Tips and Specifications
The DS200PLIBG2A unit is a Phase Logic Interface Board, although it is not considered to be the original Phase Logic Interface Board manufactured for the Mark V Series. The original Phase Logic Interface Board attributed to the Mark V Series is the DS200PLIBG2 printed circuit board, which is pointedly missing this DS200PLIBG2A PCB's A-rated functional product revision. This particular DS200PLIBG2A printed circuit board product offering is considered a highly voltage-sensitive General Electric printed circuit board product offering, which means that it is reccommended to use a standard wrist grounding strap during any installation or replacement of this DS200PLIBG2A product. With this being true, General Electric takes steps to avoid potentially-damaging transmission of surface voltages; primarily through the DS200PLIBG2A Board's acceptance of a Mark V Series-standardized selection of voltage-suppressing hardware components including different styles of Mark V Series capacitors, transistors, resistors, diodes, and finally specialized integrated circuits, as would have been made obvious in this DS200PLIBG2A device's originally-printed instructional manual materials. Additionally, each of the factory-drilled installation holes in the base printed circuit board of this DS200PLIBG2A product offering have been insulated with ringlets of copper material, in observance of potentially-present damaging DS200PLIBG2A Board surface voltages.
This DS200PLIBG2A Phase Logic Interface Board unfortunately does not seem to possess a high quantity of original product-centric instructional manual materials on the internet for research purposes. With this in mind, the DS200PLIBG2A functional product number itself is a primary source of hardware specification information for this product. The DS200PLIBG2A functional product number begins with the DS200 series tag, which has dual naming responsibilities for this DS200PLIBG2A Mark V Series product. The DS200 series tag identifies its DS200PLIBG2A printed circuit board as a domestically-manufactured PCB with a normal Mark V Series assembly version. This DS200 series tag is followed in the DS200PLIBG2A functional product number by the PLIB functional acronym, which was created as a convenient promotional and conversational shorthand alternative to the lengthy DS200PLIBG2A functional product number. This PLIC functional acronym is itself followed in the DS200PLIBG2A functional product number by the G2 series grouping tag, which also holds dual naming conventions for this General Electric product. The G2 series grouping tag here is representative of this DS200PLIBG2A PCB's normal style of printed circuit board coating and its group two Mark V Series grouping. The final A digit in the DS200PLIBG2A functional product number is a representation of this PCB's singular A-rated functional product revision.