Product Description
The GE Power Excitation Board DS200RTBAG5A is an optional board that is installed in the drive cabinet and it features ten relays that are driven either directly from the pilot relays or remotely by the user. The DS200RTBAG5A is engineered to be installed in the board cabinet on the drive but the board is usually not installed in the board rack. Instead, it is often secured below the rack and it is secured with four screws and washers on four standoffs. The standoffs raise the board above the cabinet to prevent the board from touching the metal surface of the cabinet.
To remove the board, remove the four screws and the washers and keep the screws and washers in a safe place to secure the replacement board. If one of the screws or washers falls inside the drive, you must find it to prevent damage to the components if you re energize the drive with the screw still missing.
The pluggable circuits enable you to gain access to the K27-K29 relays through connectors C1PL-C5PL and Y9PL-Y37PL. You can configure the board through jumpers to define the source of power for the relays. To attach a wire to one of the connectors, press down on the holding clip for the connector and insert the wire. Release the clip and the wire is secure. To remove a wire, press down on the clip and pull the wire out.
Before you insert the wire make sure the insulation is removed from the end of the wire that you insert in the clip.