About the IS200BPIRG1AAA
The IS200BPIRG1AAA is a PCB component for the Mark VI Speedtronic gas/steam management system from GE. The MKVI is designed on thirty years of research and development from GE, and can be used in a variety of applications. This IS200BPIRG1AAA Digital Interface Board's greater Mark VI Turbine Control System Series, as it is known at length, exists with a specific set of possible functional applications in the control and management systems of popular and General Electric-compatible gas, steam and wind turbine automated drive assemblies. This IS200BPIRG1AAA device's greater Mark VI Series is also very much desirable as a function of its status as one of the final-developed Mark product series to utilize the patented Speedtronic control system technology first seen with the initial rollout of the Mark I Series in the mid to later 1960s. This IS200BPIRG1AAA product's Mark VI Series must be defined as a significant functional upgrade on the Mark V Series of the same full extended series title, as the Mark VI Series tacked the alternative energy-focused wind turbine possible application onto the gas and steam-based functional environments seen with the earlier rollout of the Mark V Series.
Hardware Tips and Specifications
The IS200BPIRG1AAA functions as a Digital Interface Board within the MKVI system. This board is used in Innovation Medium Voltage/GP Type H drives. The IS200BPIRG1AAA provides a 15V to 5V bus interface (digital) between the BICR Bridge Interface Board and the FOHB Fiber-Optic Hub Board. Phase reference analog signals and bridge cell temperatures also pass through this board. The IS200BPIRG1AAA includes two board connectors. The first is P1, located along the back edge of the board, which is a backplane connector. It is important to note the backplane connector on this board may need a custom extender board to access individual pin signals. The other connector is a 50-pin ribbon connector marked PLO. This connects the FOHB to the BPIR board. The IS200BPIRG1AAA includes a 1024-bit memory chip. This includes revision information and board identification information. It is accessed through a data line on the P1 connector. The board also has four TP test points. These are labeled REF A, REF B, REF C, and ACOM. The board has a single relay, several resistors, a transistor, and six integrated circuits. The IS200BPIRG1AAA should be treated as a static-sensitive board. AX Control will ship the board protected by an antistatic bag. Technicians should use a grounding strap when unpacking, installing, or handling this board.
This IS200BPIRG1AAA device's above-attached instructional manuals and datasheets assert a number of important IS200BPIRG1AAA Board hardware qualities that are quite pertinent to this IS200BPIRG1AAA personalized product page here. For starters, this IS200BPIRG1AAA device is actually not the original Digital Interface Board that was developed by General Electric for placement in their popular industry-standard Mark VI Turbine Control System Series automated drive assembly. That product would have to be considered as the IS200BPIRG1 parent Digital Interface printed circuit board notably not taking advantage of this IS200BPIRG1AAA device's three-fold revision table. To be specific, this IS200BPIRG1AAA product is edited from its base version through two functional revisions and and artwork configuration revision all rated at grades of A. This IS200BPIRG1AAA devices offers some of the diagnostic protections of Mark VI Series fame through its series of test points, with each test point being accompanied by their own factory-printed nomenclature label starting with TP. Some of this IS200BPIRG1AAA product's individual testpoints include the:
- TP1-REFA Analog Phase A Reference Signal Testpoint
- TP2-REFB Analog Phase B Reference Signal Testpoint
- TP3-REFB Analog Phase C Reference Signal Testpoint
- TP4-ACOM Analog Reference Common Testpoint
