About the IS200CPFXG1AAA
This IS200CPFXG1AAA Phase Leg Flash Protection Board printed circuit board product offering from General Electric was originally designed and manufactured specifically for placement in the Mark VI Turbine Control System Series. The Mark VI Series that this IS200CPFXG1AAA Phase Leg Flash Protection Board device was originally manufactured for exists with a set of specific possible applications in the control and management systems of GE-compatible gas, steam, and wind turbine automated drive assemblies. This in this instance can be considered quite the considerable functional upgrade upon the previously-developed Mark V Turbine Control System Series of a similar full extended series title, given the fact that the Mark V Series' established gas and steam turbine application range was expanded to include the Mark VI Series' soon to come wind turbine alternative energy-based functional application. This IS200CPFXG1AAA Phase Leg Flash Protection Board PCB's Mark VI Series is also held in high esteem as a final-developed GE Mark product series powered through the Speedtronic control system technology.
Hardware Tips and Specifications
Equipped with one isolation transformer (T1) and two connectors (J1, J2), the IS200CPFXG1AAA is a Phase Leg Flash Protection Board produced by General Electric. The primary function of the IS200CPFXG1AAA board is to isolate the power supply associated with the IS200PICH Phase Interface and Control Board. There is a single CPFX board per phase leg and a single IS200 Control Power Flash Protection Board per bridge. Several outputs from the Control Power Flash Protection Board connect to each individual Phase Leg Flash Protection Board. When the CPFX board is operating with the PICH board, it will isolate the power of a single phase leg from the other phase legs. The Phase Leg Flash Protection Board (CPFX) does not contain any LED indicators, testpoints, fuses, or user adjustable hardware. It does have two plug connectors and flying leads from the transformer to the CPFX board. Additionally, it connects to the CPFP board and the PICH board. More information on each CPFX Board Connector can be located in the GEI-100414 user manual; for example, the J2-1 Pin is a high frequency power supply input from the PICH board.
The CPFX board was designed to not only function as a Phase Leg Flash Protection Board for the Mark VI Series, but also for other Innovation Series Drives (which are also produced by General Electric). This IS200CPFXG1AAA Phase Leg Flash Protection Board device is actually offered online with a surprising amount of originally-printed Mark VI Turbine Control System Series instructional manual material, likely due to its further classification in the Innovation Series. According to these original manual materials, no fuse, piece of user-adjustable hardware, or even testpoint is available to the normal Mark VI Series assembly of this IS200CPFXG1AAA Phase Leg Flash Protection Board product in an unfortunate turn. With this being the case, this IS200CPFXG1AAA Phase Leg Flash Protection Board printed circuit board or PCB for short Also as according to this set of original datasheets attached above for your convenience of research, this IS200CPFXG1AAA Phase Leg Flash Protection Board device's various dc bus neutrals and positive negative dc buses must be contacted by several safety ground components to encourage the shortening of relevant bus capacitors. This IS200CPFXG1AAA Phase Leg Flash Protection Board PCB's dc bus grounding is made more obvious in pictoral form in the IS200CPFXG1AAA Phase Leg Flash Protection Board manual.
