About the IS200DTTCH1ABB
This IS200DTTCH1ABB Simplex DIN-rail Mounted Thermocouple Terminal Board printed circuit board product offering from General Electric was originally designed and manufactured specifically for placement in their Mark VI Turbine Control System Series, as should have been revealed just above. The Mark VI Series that this IS200DTTCH1ABB Simplex DIN-rail Mounted Thermocouple Board belongs to must be defined as quite the significant functional improvement upon the existing Mark V Turbine Control System Series of a similar full extended series title, as the Mark V Series' established gas and steam turbine environments were expanded to include the alternative energy-based wind turbine functional product application first seen with the introduction of the Mark VI. This IS200DTTCH1ABB Simplex DIN-rail Mounted ThermocoupleTerminal Board device's great Mark VI Turbine Control System Series is also additionally valued on relevant promotional markets for its status as one of the final-released GE Mark product series to incorporate the patented Speedtronic control system technology into a wide range of different member devices.
Hardware Tips and Specifications
The IS200DTTCH1ABB model is a Simplex DIN-Rail Mounted Thermocouple Terminal Board was designed with twelve thermocouple inputs that will connect to the VTCC thermocouple processor board through a singular thirty-seven-pin cable connector. If two DTTC boards are being used then they will connect to the VTCC and a total of twenty-four inputs will be used. If more than one board is being used then there is the possibility for the boards to be stacked vertically on the DIN rail to save cabinet space. The IS200DTTCH1ABB model is typically used for temperature monitoring general purpose I/Os. Characteristics of the DTTC board are the input types. The input types for the DTTC board are either grounded or ungrounded E, T, K, and J inputs. The thermocouples of this device are wired directly to the terminal block. There is a Euro Block type terminal block with forty-two terminals, the Euro Block terminal is permanently mounted on the DTTC board.
As mentioned above the IS200DTTCH1ABB model is used for temperature monitoring inputs and outputs, there are three other terminal boards that can be used alongside the DTTC model. The three termination boards that can be used are the DTAI, TBTC, and TRTD boards. The TBTC board is the barrier termination board to the DTTC termination box. The DTTC model will primarily be used with a standard control module but it can be used with a Backup Protection Module. When using the DTTC module with the backup protection module up to nine extra thermocouples can be monitored. For more information regarding how the DTTC module can be used with more temperature monitoring I/Os refer to the GER-4193A Mark VI Turbine Control System or the GEH-6421C Mark VI System Guide. This IS200DTTCH1ABB Simplex DIN-rail Mounted Thermocouple Terminal Board is actually not the originally-developed device of its specific GE Mark Series functionality, as that would have to be considered the IS200DTTCH1 Parent Simplex DIN-rail Mounted Thermocouple
Terminal Board notably not adopting this IS200DTTCH1ABB device's:
- A-rated primary functional product revision
- B-rated secondary functional product revision
- B-rated artwork configuration product revision
