About the IS200TBAIH1CDC
This particular IS200TBAIH1CDC Analog Input Terminal Board printed circuit board product offering or PCB for short was originally designed and manufactured, as specifically mentioned above, for a functional placement within the Mark VI Turbine Control System Series. The Mark VI Series immediately succeeded the Mark V Turbine Control System Series of the same full extended series name from GE, tacking the crucial alternative energy-focused wind turbine set of functional applications upon the previously-known steam and gas turbine possible functional settings available to the Mark V Suite. This IS200TBAIH1CDC Analog Input Terminal Board product's Mark VI Turbine Control System Series is additionally seen as a desirable GE Mark product series on the greater promotional automated industrial community given its status as one of the last-developed GE Mark product series to accept the esteemed Speedtronic control system technology into the assemblies of many various devices.
Hardware Tips and Specifications
The Analog Input Terminal Board IS200TBAIH1CDC manufactured by General Electric for the Mark VI system is typically used with an Analog Input Board (VAIC) in Simplex or TMR applications. When the TBAI is used with the VAIC module, up to two TBAI boards can be used, each of the TBAI boards will have ten inputs and two outputs. Between the analog inputs and outputs, there are twelve I/Os; two are analog outputs, with the remaining ten being analog inputs. There are a variety of characteristics of the inputs and outputs for this board. The characteristics are as follows:
- 500 Ohms (4-20 mA) or 50 Ohms (0-200 mA) output
- 250 Ohms (4-20 mA) or +/- 5,10 VDC inputs
- Current Limited +24 volts of direct current provided per inputs
- 0.2 A, +24 V current limited power sources
- 500 Ohms (4-20 mA) output
- 250 Ohms (4-20 mA) or 500 Ohms (+/- 1 mA) inputs
These inputs and outputs are only a portion of the inputs and outputs required to run alongside the VAIC card; the other portion will be run through another termination board. The above information is received from either the GER-4193A Speedtronic Mark VI Turbine Control System Manual or the GEH-6421C Vol. II Mark VI System Guide. The list of characteristics comes from the GER-4193A manual from Table Two on page four. General information regarding how the IS200TBAIH1CDC and VAIC models will interact can be found on pages 9-47 to 9-55 in the GEH-6421C Manual. The VAIC Module mentioned in the above-attached IS200TBAIH1CDC Analog Input Terminal Board original instructional documentation and datasheets is additionally available right here at AX with both repair and replacement options at the ready; either in new or reconditioned condition as similar to this IS200TBAIH1CDC Analog Input Terminal Model. This IS200TBAIH1CDC printed circuit board or PCB for short is actually not the originally-developed Mark VI Series product of its specific functional role, as that would have to be considered the IS200TBAIH1 parent Analog Input Terminal Board notably not utilizing this IS200TBAIH1CDC Analog Input Terminal Board's three-fold significant product revision history.
