About the IS200VSCAH2A
The IS200VSCAH2A is a board component made by GE for the Mark VI system. The MKVI was released by General Electric under the Speedtronic name, which is a long-running gas and steam turbine management program. The Mark VI is an advanced turbine control system that uses Ethernet communications and that has a connected Operator Interface made from a PC running on a Windows platform.his includes oscillating chips, universal asynchronous receiver transmitters, and an FPGA (field programmable gate arrays.) This IS200VSCAH2A PCB's greater Mark VI Turbine Control System Series is quite the significant functionality-minded upgrade upon the Mark V Turbine Control System Series of essentially the same full extended series title that immediately preceded it, as the Mark V Series's established gas and steam turbine-based functional possible application range was added on to by the alternative energy-minded wind turbine application with the introduction of the Mark VI Series. This IS200VSCAH2A PCB's Mark VI Series is additionally valuable in general for its status as one of the last-developed Mark product series utilizing the patented Speedtronic control system technology.
Hardware Tips and Specifications
The IS200VSCAH2A functions as a Serial Communication Input Output board. This component provides I/O interfaces for independent devices that can use RS-422, RS-485, or RS-232C serial communication. The board uses a (DSCB) terminal board to connect through the front panel connectors to these independent devices. RS-232C serial connections have a maximum cable length of 50 feet. Other connections may be cabled up to 1000 feet. The IS200VSCAH2A has a front faceplate. This is a single slot board that includes multiple components like three LED components.These are labeled Run, Fail, and Status. The status light will only power when a diagnostic alarm condition is present. The IS200VSCAH2A is built with nineteen jumper switches. This includes three-position jumpers for selecting electrical characteristics of ports(JP1-JP6,) for the configuration of transmission lines (JP7-JP12,) or for the selection of termination configuration for the receive lines (JP13-JP18.) The board also has one two-position jumper switch (JPU1) that is used to select between Modbus operation and Honeywell pressure transducer. The board has capacitors, resistors, and transformers; all parts of a greater voltage regulation strategy that was standardized to the rest of this IS200VSCAH2A device's greater Mark VI Turbine Control System Series.
The IS200VSCAH2A is built with over forty integrated circuits. All of the above-included IS200VSCAH2A Board-specific hardware information within the bounds of this IS200VSCAH2A personalized product page here has been sourced purely from a diligent visual inspection of the IS200VSCAH2A device itself, as led by one of our diligent and experienced in-house service technicians. This was deemed necessary given the lack of Mark VI Series instructional manual materials available online; a lack that calls the IS200VSCAH2A functional product number into question as a fine supplementary source of IS200VSCAH2A Board hardware information. The IS200VSCAH2A product number codes for a series of individual relevant IS200VSCAH2A PCB details through its series of consecutive naming elements. For starters, this IS200VSCAH2A product number begins with an inclusion of the dual-functional IS200 series tag delegating this IS200VSCAH2A Board's normal Mark VI Series assembly as well as its domestic GE manufacture location. Some other IS200VSCAH2A Board details embedded in this medium include its:
- VSCA functional product acronym
- Group 2 Mark VI Series grouping
- Conformal PCB surface coating
- A-rated functional product revision
