About the IS200VTURH1BAA
The IS200VTURH1BAA board is part of the GE Mark VI Speedtronic system. This control system is used for the control and maintenance of steam or gas industrial turbines. The Mark VI Turbine Control System Series that this specific IS200VTURH1BAA Primary Turbine Protection Card device is a component member of must be considered a whole functional upgrade from the previous industry-standard Mark V Turbine Control System Series of more or less the exact same full extended GE product series title, as the Mark VI Series embraced the alternative energy-focused wind turbine automated drive application, adding on to the gas and steam-based turbine environments previously established through the Mark V Series. This IS200VTURH1BAA Primary Turbine Protection Card product's greater Mark VI Series is also held in high esteem as one of the final-produced GE Mark product series making use of the patented Speedtronic control system technology across a range of devices.
Hardware Tips and Specifications
The IS200VTURH1BAA is a primary turbine protection card. This IS200VTURH1BAA Primary Turbine Protection Card product's IS200VTURH1BAA Primary Turbine Protection Card functional product number describes a series of relevant IS200VTURH1BAA Primary Turbine Protection Card Board hardware specifications through a series of consecutive functional naming chunks. Some of these specific details include this IS200VTURH1BAA Primary Turbine Protection Card product's domestic original GE manufacture location, its group one Mark VI Series product grouping, its conformal PCB Coating style, and its three-fold significant product revision table. Some of the various functions of this IS200VTURH1BAA Primary Turbine Protection Card Mark VI Series product include:
- Controlling (3) overspeed trip relays located on the TRPx terminal board. This board has nine magnetic relays that are interconnected with three trip solenoids. In TMR systems all nine relays are used. In Simplex systems, only three relays are used.
- Monitoring (8) Geiger-Mueller flame detectors. These are used only in gas turbine applications.
- Monitoring induced shaft current and voltage
- Closing the main breaker/providing automatic generator sync.
- Measuring turbine speed using (4) passive pulse rate devices.
The IS200VTURH1BAA can be installed in a VME processor rack only when it is powered down. The board should be pushed in using the top and bottom levers to seat edge connectors. Then use the captive screws (top and bottom) to secure the board into place within the rack system. The narrow front panel has only these captive screws, a single d-shell connector, and three LED indicators. The indicators are labeled Status, Fail, and Run. The board is designed to measure turbine speed from up to four pulse rate signals. This is in simplex applications. The board can also be used in TMR applications but picks up signals differently. For more information regarding the IS200VTURH1BAA, please refer to publications from General Electric that provide information, such as product user guides or Mark VI manuals. These will also have important information regarding handling and installation processes.
