About the IS200WDIIH3A
The IS200WDIIH3A is a PCB manufactured by GE Industrial Drive Systems. GE Industrial Drive Systems is a subsidiary company of the greater General Electric automated industrial retailer that was chiefly responsible for the manufacture of this IS200WDIIH3A Daughter Board device's Mark VI Turbine Control System Series, which would have been revealed above in the brief IS200WDIIH3A Daughter Board product description paragraph. The Mark VI Series that this IS200WDIIH3A Daughter Board device belongs to, for all intents and purposes, must be considered a massive functional improvement upon the previously-existing Mark V Turbine Control System Series of almost the exact same full extended product series title, as the Mark VI Series added the alternative energy-minded wind turbine functional application onto the gas and steam applications established in the earlier Mark V Series. This IS200WDIIH3A Daughter Board product's Mark VI Series is also valued as one of the final-developed GE Mark Speedtronic-powered series.
Hardware Tips and Specifications
The IS200WDIIH3A functions as a daughter board in the application and has two connector ports by which cables can be attached. The IS200WDIIH3A is a rectangular board with components on both surfaces. The bottom surface has a single backplane connector (P1) with 48 male pins. The rear surface is also marked RA/00. The front surface has two female plug connectors that are labeled JE1 and JE2. These are positioned side-by-side on the right side of the board. The front surface of the IS200WDIIH3A has a single metal oxide varistor. Varistor components change their electrical resistance with the applied voltage. The board also has sixteen fuses (TR1 and TR16) that are located on the board in two lines of eight. The bottom of the board has three lines of light components that are labeled D2, B2, and Z2. The IS200WDIIH3A has the following components:
- A heat sink component attached to the board on the left side of the board.
- Several lines of diodes
- Multiple capacitors and resistors.
- In the top left corner of the board there is a single component that is marked “DN1.” This is a single phase D.I.L rectifier bridge.
Please contact GE for manuals, datasheets, and other documentation. Unfortunately, many of these originally-printed instructional manual materials are rather obscure and difficult to retrieve online, given the numerous and repeated copyright infringements that were levied against General Electric in the many years past its original Mark Series rollout. With this being the case, the IS200WDIIH3A Daughter Board functional product number itself can be introduced as a fine supplementary source of IS200WDIIH3A Daughter Board hardware component and component specification information, as it reveals a number of critical IS200WDIIH3A Daughter Board details through a set of consecutive functional naming segments. For instance, this IS200WDIIH3A Daughter Board product number in particular is kicked off through its inclusion of the initial dual-responsible IS200 series tag that delegates both this IS200WDIIH3A Daughter Board product's normal Mark VI Series assembly on top of its domestic original location of General Electric manufacture. Some of the other relevant details revealed through the IS200WDIIH3A Daughter Board product number include its WDII functional acronym, its group three grouping, its conformal PCB coating, and last but not least its A-rated functional product revision.
