IS210DSVOH1AA

About the IS210DSVOH1AA

The board model IS210DSVOH1AA is a Simplex DIN-Rail Mounted Servo Terminal Board. This board is equipped with six LVDT sensors, two active pulse rate inputs, and two servo valve outputs. The pulse rate inputs on the DSVO board are used for flow measurement. There are also servo coil currents that are used with this module, the coil currents can be jumper selected that is in the range of ten to one hundred and twenty milliamperes. One other major function of the DSVO board is the high frequency and onboard decoupling to the ground. These two functions are the exact same as those on the TSVO. 

A few major components of the IS210DSVOH1AA are the two sub-D pin connectors and the Euro block terminal block. While the Euro block looks like it might be able to be removed from the board but it is actually permanently mounted to the board through six screws typically used for SCOM or ground connection. The two sub-D pin connectors are made up of different pins, the connector that is located closer to the left-hand side of the board is made up of fifteen pins, and the connector closer to the right-hand side of the board is made up of thirty-seven pins. 

There are two different types of DSVOH1 boards, as an IS210DSVOH1AA board there are a certain number of terminals with the Euro block terminal as mentioned above. This specific Euro block has thirty-six terminals. A shielded wiring type is also required when using this model, the shielded wiring type used is an #18 AWG wire. If you would like more information regarding this model please refer to General Electric Manual GEH-6421C.