About the IS215GFOIH1AB
This IS215GFOIH1AB Printed Circuit Board was manufactured for General Electric's Mark VI Turbine Control System Series, as should have been exposed above. The Mark VI Turbine Control System Series that this IS215GFOIH1AB Printed Circuit Board product offering belongs to has to be considered something of a massive functional improvement upon the previous industry standard of the Mark V Turbine Control System Series, as this IS215GFOIH1AB Printed Circuit Board product's Mark VI Series was developed to add the more alternative energy-based wind turbine possible functional application to the rudimentary gas and steam turbine-based application range established with the Mark V Series of a similar full title.
Hardware Tips and Specifications
The IS215GFOIH1AB board is marketed as a printed circuit board. It can be used with two different types of turbines, either steam or gas turbines. The location of this model can be used with two different architecture redundancy types, simplex or triple modular redundant. When the model is being used with a triple modular redundancy system it will be used with power supplies, Control Modules, and IONets, all of which are completely separate and independent. The VME racks that the Mark GFOI board will be used with are either thirteen or twenty-one slots, this model will only take up one of those slots. This IS215GFOIH1AB Printed Circuit Board device's IS215GFOIH1AB Printed Circuit Board functional product number can be rolled out as a fine original source of IS215GFOIH1AB Printed Circuit Board hardware component and component specification information, being that it was developed to code for a number of important IS215GFOIH1AB Printed Circuit Board details through a series of consecutive functional naming tags. For example, this IS215GFOIH1AB Printed Circuit Board product number begins with an inclusion of the typical IS215 series tag indicating this IS215GFOIH1AB Printed Circuit Board product's special modular assembly on top of its standard domestic GE manufacture location. Some of the other important IS215GFOIH1AB Printed Circuit Board details indicated through the IS215GFOIH1AB Printed Circuit Board number medium are its:
- GFOI functional product acronym
- Group one Mark VI Series grouping
- Conformal PCB coating style
- Two-fold revision table
When looking at the IS215GFOIH1AB board you will notice that in the middle of the board, there is an additional board, this additional board is labeled as a KSPA model. The KSPA model is an attached daughter board and is typically used for signal processing. The front faceplate of this board has several connectors, two of which are sub-D pin connectors which are labeled as a serial ports, and an I/O interface connector. There are also three indicator components and six HFBR-0400 Series components. The latter of these components are used for communication via fiber optics. Unfortunately, due to being out of production the IS215GFOIH1AB board has very little information available. Most of the above information was taken from a visual inspection of the board as well as from a Mark VI Turbine Control System Instruction Manual which is labeled as GER-4193A. The GER-4193A manual can be found above located under the manual tab.
