IS215VPROH2BD

About the IS215VPROH2BD

Model IS215VPROH2BD was designed as part of the Mark VI Series from General Electric. This specific model is referred to as a Protection Assembly Board. The model is considered obsolete by General Electric as it is no longer actively produced. When being used in the Mark VI System the board has the ability to be fully programmed. The typical power source for this model is in the range of one hundred twenty to two hundred forty volts of alternating current. 

The IS215VPROH2BD board has fully programmable software which will have rates of around ten, twenty, or forty milliseconds. These frames are typically the elapsed time in which inputs will be read, conditioned, and will execute the chosen application software. Once these functions have been performed the outputs will then be sent out across the rest of the Mark VI System. 

There are some diagnostic LEDs on the front faceplate of the IS215VPROH2BD board, some of the LEDs are run, status, and fail LEDs. Typically the LED colors are green for the run, yellow for status, and red for fail. If this board requires a reset there is a reset button located on the front of the board. 

As mentioned above this board is obsolete. Due to its obsolescence, it is difficult to obtain. For more information about the availability of this model please reach out to the AX Control sales department which can give you more accurate information on whether or not the model is available at this time.