About the IS220PPRFH1A
Model number IS220PPRFH1A is described within the Mark VI series produced by General Electric as a PROFIBUS Master Gateway Module. While this model was designed to be used in the Mark VI series, it can also be used in the Mark VIe and Mark VIeS series. The Mark VI Turbine Control System Series, as it is known at length, has to be described as something of a self-described GE Mark product series, as it exists with a set of specifically-possible functional applications in the control systems and management systems of GE-compatible gas, steam, and wind turbine automated drive assemblies. This must be considered a massive upgrade upon the previously-existing Mark V Turbine Control System Series of the same full extended series name, as the Mark V Series' potential applications were limited to gas and steam-based applications alone.
Hardware Tips and Specifications
The PPRF model is considered an analog output pack and is often used with the IS200SPIDG1A accessory ID board. Together the I/O pack and the terminal board were rated and approved for hazardous and non-hazardous locations, which is almost certainly the root cause of this IS220PPRFH1A Mark VI Turbine Control System Series product's initial classification as a "HazLoc" device. When the IS220PPRFH1A model is being used, there are electrical specifications that must be followed so as to eliminate potential property damage or some cases, personal injury. There are two specifications, labeled voltage and current. The power supply voltage has a range of 27.4 to 28.6 VDC, with the nominal voltage supply being 28.0 VDC. The power supply current used by the PPRF pack is a maximum of 0.18 ADC. There is also a specific temperature range the PPRF model must be used in; defined as an ambient temperature rating, this temperature range is -4 to 131°F or -20 to 55°C.As mentioned above, the IS220PPRFH1A model was rated for use in hazardous and non-hazardous locations. For each location, there is a listing certification. The non-hazardous certification is UL E207685, which is the same as the Class I, Division 2, Groups A, B, C, D, and Class I, Zone 2, Group IIC certifications. The certification for ATEX Zone 2, Group IIC is UL DEMKO 12 ATEX 1114875X
For more certifications, refer to the GEH-6725 Mark VIe and Mark VIeS Controls Equipment HazLoc manual. While this IS220PPRFH1A device's various electrical requirements and voltage ratings are certainly important to understand eventually, their presence on this IS220PPRFH1A personalized product page here is really more telling of the sparsely-available nature of this IS220PPRFH1A device's originally-printed instructional manual materials on the internet. With this lack being identified, this IS220PPRFH1A product's IS220PPRFH1A functional product number itself can be rolled out as a decently-strong primary information source of IS220PPRFH1A Board hardware detail, as it codes for individual pieces of information through a characteristic series of consecutive functional naming components. This IS220PPRFH1A functional product number is started through an iteration of the dual-responsible IS220 series tag delegating both this IS220PPRFH1A product's special modular Mark VI Series assembly on top of its typical domestic GE original manufacture location. Some of the other relevant IS220PPRFH1A PCB qualities revealed through this medium include the IS220PPRFH1A device's PPRF functional product acronym, conformal PCB coat of protection, Group one Mark VI Series grouping, and finally its sole A-rated product revision.
