About the 6KLP23F50X9A1
6KLP23F50X9A1 is an AF-60LP Micro Drive that is manufactured by GE. This particular 3-phase drive has an input voltage of 208/230 volts. The horsepower rating is 0.50 HP. Before commencing repair work, disconnect the drive from the mains and the external DC supply (if present), wait for the discharge of the DC-link, disconnect the DC bus terminals and the brake terminals (if present), and remove the motor cable. The operator may mount the frequency converters side-by-side, but 100 mm of clearance must be left above and below the controller for cooling. Cables must have copper conductors and must comply with national and local regulations for cable cross-sections and ambient temperatures.
The installation of the drive is protected against electrical and fire hazard by the branch circuit protection. For the short circuit protection, the drive is suitable for a circuit capable of supplying a maximum of 100,00 Arms (symmetrical) at a maximum of 480 volts. The overcurrent protection against the overheating of cables in the installation (must be carried out according to national regulations). In case of malfunction, not following the fuse recommendation detailed in the user instruction manual may damage the frequency converter. The display for this micro drive is VGA (800 x 600) or higher resolution. The display has 16 colores. 200 MB of available space is required on the system drive for the DCT-10 Set-Up Software hard disk. The virtual memory requirements are 1 GB for working with big project files such as 50+ drives.