Frequently Asked Questions about 7VYJS541CD01
What does the error number ER05 mean?
The error number ER05 has an error name BTIMR and means the timers in the 8031 Chip are faulty.
-Replace the Programmer card.
What does the error number ER06 mean?
The error number ER06 has an error number NADDR and means that there are NO address or an incorrect address specified before pressing "Enter".
-Re-enter Parameter address.
What does the error number ER07 mean?
The error number ER07 has an error name 2 KEYS and means that two keys were pressed together.
-Press keys one at a time.
What does the error number ER08 mean?
The error number ER08 has an error name ILBRD which means that it was illegally broadcast.
-Check the format of the message that was sent.
What does the error number ER11 mean?
The error number ER11 has an error name NOACK and means that there is NO acknowledgment is received.
-Wires to the serial link are disconnected.
-There is noise on the transmission wires.
-The RS232 or Hand-held Programmer cable had failed.
What does the error number ER12 mean?
The error number ER12 has an error name N CTS and stands for not "Clear to Send".
-Serial link transmission lines are disconnected.
-Check the JP3 and the JP4 on the Programmer card.
What does the error number ER13 mean?
The error number ER13 has an error name ORBUF and means that the receiving buffer has overflowed.
-The baud rates are set incorrectly.
-The protocol was set incorrectly.
-The incorrect RS232 or RS422 hardware wasn't configured properly.
What does the error number ER14 mean?
The error number ER14 has an error name CKSUM and means the incorrect checksum was received.
-The baud rates were set incorrectly.
-The protocol was set incorrectly.
-The incorrect RS232 or RS422 hardware wasn't configured properly.
What does the error number ER15 mean?
The error number ER15 has an error name BDMSG which means there is a bad message.
-The "Start of Transmission" byte not received.
-The baud rates were set incorrectly.
-The protocol was set incorrectly on the external device (1 start bit, 8 data bits, and 1 stop bit).
-The hardware configuration is incorrect.
- The incorrect RS232 or RS422 hardware is configured incorrectly.
