About the 6KE1123001X1A1
The part with the number 6KE1123001X1A1 is featured in the AF-300 E11 series made by Fuji Electric. This is a single horsepower drive. This drive has a 4.0 output current, and a 6.0 overload. This device weighs 3.1 pounds. This drive is a part of the 230 VAC, 3 phase, 50/60 Hz input. This drive has a watt loss at 15 KHz (W) of seventy-seven. There is a watt loss at 0.75 KHz (W) of fifty-seven. The efficiency of this drive at 15KHz (%) is ninety-two point four. The efficiency of this drive at 0.75 KHz (%) is ninety-four point two. This drive has a 0.75 rated output rating (KW). The device has a 1.6 rated output power (KVA). The drive has a rated output current of four. The atmosphere for this drive inverter must not be exposed to direct sunlight, vapor or water drops, dust, oil mist, or corrosive gases. This drive is for indoor use only. To store this drive short term do not place the drive on the floor. If the ambient temperature is adverse, wrap the drive in a vinyl sheet or similar protection when storing. If humidity may be present, add a drying agent (such as silica gel packets) in the package. The long-term storage method of the drive varies largely according to the environment of the storage site. General storage methods are described below. (1) The storage site must satisfy the requirements of specifications for temporary storage. However, for storage exceeding three months, the upper limit of the ambient temperature shall not exceed 30 °C. This is to prevent deterioration of unpowered electrolytic capacitors. (2) The package must be airtight so that moisture will not enter. Add a drying agent inside the package to maintain a relative humidity inside the package of 70%. (3) A drive installed in a unit or control panel and stored is likely to be exposed to moisture and dust. If this is the case, remove the drive and move it to a preferable environment, as in item (1) or (2). (4) Electrolytic capacitors left unpowered for an extended period of time deteriorate. Do not store for more than one year without applying power to the drive.
