About the 6KE1123002X1A1
The 6KE1123002X1A1 is a two-horsepower drive from Fuji Electric. This drive is a part of the AF-300 E11 series. The drive weighs five pounds, with an output current of seven and an overload of ten and a half. The drive can be found in the 230VAC 3phase, the 50/60Hz input section of the AF-300 E11 series. The ground terminal G should always be connected to the ground. Don’t use RCD as the sole method of electric shock protection. Sizes of external PE (ground) conductor should be the same size as the input phase conductor and capable of the same fault currents. Do not remove the keypad panel before disconnecting power and do not insert/remove the extension cable for remote keypad panel while power is on. Confirm that the extension cable is securely latched to keypad panel and the drive. Do not connect the copper wire to ground terminals directly. Use crimp terminals with tin or equivalent plating to reduce electrochemical action. The drive has to be installed in the environment of pollution degree 2. If the environment is pollution degree 3 or 4, the drive has to be installed in a cabinet of IP54 or higher. Remove the control terminal block cover to connect to the control terminal block. Remove the main circuit terminal block cover to connect to the main circuit terminal block. Refer to the AF-300 E11 series instruction manual for information on storage, installation, and troubleshooting for this drive.
AX Control’s professional staff is standing by to assist you by email or by phone.
