IC300DQM202

About the IC300DQM202

The IC300DQM202 unit is a relay output module that was made by GE Fanuc for the SmartStack series. The IC300DQM202 relay output module can usually be found within AX Control’s stock, so be sure to contact us to find out if it is currently in our inventory.

The IC300DQM202 relay output module has a total of 8 normally open relay outputs, all of which are consumed, and only one common. The isolation, both channel to bus and channel to channel, is rated at 500 VDC and the operating voltage is 12 to 32 VDC. At steady state, the required power is 0.13 W, or 5.5 mA at 24 VDC. When turned on, the voltage level is 0.15 V. The maximum load voltage is 250 VAC and 30 VDC, the maximum inrush current is 10 A, and the maximum load current is 4 A. The IC300DQM202 relay output module has an OFF to On response time of at most 10 ms and the ON to OFF response time is half that at 5 ms. 

The IC300DQM202 relay output module has an internal 10 A fuse that cannot be replaced. In addition to that, the module has reverse polarity protection.

When you are ready to start the installation process of the IC300DQM202 relay output module, you will need to ensure that the conditions of the installation environment are adequate. The relative humidity must be non-condensing and anywhere within the range of 5 and 95% and the operating temperature must be anywhere in the range of 0 and 60 degrees Celsius.