About the IC620MDR128
The IC620MDR128 is a GE Fanuc Programmable I/O Controller Unit. There is a good chance it was also produced by Fanuc depending on what year it was actually being sold. Neither of these two companies still have support available for this part. AX Control does tend to keep this part in stock though. Please see our website for the availability status of the IC620MDR128.
The IC620MDR128 is a 28-Point CPU Unit that was produced for a GE Fanuc Micro series PLC. This device weighs about 490 grams or 1lb. It is 80mm high, 218mm wide, and 76mm thick. It has a power consumption of 13.5 watts at 24 VDC. It has a power supply voltage of 10-28 VDC and 12-24 nominal VDC. It has a total clock speed of 12MHz on its microprocessor. It has a 50 msec at 85 VAC power input volt drop and interruption rate.
The IC620MDR128 has 16 DC input points from its logic circuitry that are optoisolated. These inputs have an 8.4 milliamp input current. They have an input impedance of 3K ohms. They have an off-level of 11 VDCs or higher and an on-level of 10.8 VDCs. It has an on-to-off response time of 11msec and an off-to-on response time of 7msec.
The IC620MDR128 has 12 N.O. electromechanical relay output contacts. They have an applicable load of 5VDC at 1mA. These outputs have a maximum independent terminal voltage of 250 VAC at 5A and 30 VDC at 5A. They have a maximum common terminal voltage of 250 VAC at 5A per common and 30 VDC at 5A per common. They also have a minimum load of 5VDC at 1mA.
