IC609TCU100

About the IC609TCU100

The IC609TCU100 module is a Timer/Counter Setpoint unit for Series One Junior CPU units, all of which were made by GE Fanuc. The IC609TCU100 Timer/Counter Setpoint unit will regularly be seen within our stock at AX Control. You can look on this page on our website for details on its availability and give us a call if you would like further details on its availability or for ordering information.

The IC609TCU100 Timer/Counter Setpoint unit is a small, square-shaped device. On its top part, there are a few components and plenty of white text. The top left corner of the IC609TCU100 Timer/Counter Setpoint unit’s faceplate is home to two small LEDs, one green LED that is labeled as “RUN” and one red LED that is labeled as “CPU.” Directly below those two LEDs, there is a long, thin male port. To this port’s right, you will find some cautionary text.  This text reminds the user that the power must be off when mounting or removing the device. Also, this text says that the CPU may read an incorrect value if a switch position is altered during operation. Below the cautionary text is some text which lists the references for Series on Junior and Series One Plus. On the far right side of the IC609TCU100 Timer/Counter Setpoint unit’s faceplate, there are four timers that all have four digits. These timers have both their REF and REG values listed next to them.

This device has four circuits, which each have four BDC digits. The IC609TCU100 Timer/Counter Setpoint unit also has an internal power consumption maximum of 5 VDC, 40 mA with a minimum of 9 VDC, 5 mA. At 5 VDC, the IC609TCU100 module can handle 4 units of load. At 9 VDC, the IC609TCU100 module can handle 1 unit of load.

The IC609TCU100 Timer/Counter Setpoint unit weighs about 4.40 lbs. or 1.99 kg.