IC800VMCP3030

About the IC800VMCP3030

The IC800VMCP3030 is a 3000w Power Cable for a VersaMotion Servo. It was created by GE FANUC.

The IC800VMCP3030 is 3 meters long and weighs 3 lbs. This cable is used to connect the servo motor and the servo drive’s U, V, and W terminals. This power cable does not come with a brake option. The cable has a round plug that goes directly into the servo motor. The other end of the cable has separate wires used to plug into the servo drive.

When installing the IC800VMCP3030, make sure you do not bend or strain the cable. Please see the product manual for wire gauge recommendations for this product. To avoid wear and tear on this cable make sure you do not put it in the same conduit as your encoder cables. Separating then will also cut down on signal noise. It is recommended that you connect the wiring to the servo motor after the terminal blocks are removed. To prevent shock or short circuits make sure you check all wiring connections before powering up the servo motor.

When available, the IC800VMCP3030 can be shipped today if ordered by 4 pm on standard business days from AX Control. To request a price quote or to request a repair on an item, click the two blue icons and fill out the submission forms. A representative will contact you with a formal quote within about 15 minutes during normal business hours.  If you have any questions please do not hesitate to call or email us, we are here to help you.